Press Releases 1 to 6 of 32
14.02.2019 10:00 New CAN (FD)/LIN Network Interface for PCIe
Stuttgart, GERMANY, 2019-02-14 – Vector presents its latest network interface: the VN1530. Users will benefit from four onboard channels and two additional piggybacks which can be used flexibly. This gives them many different channel combinations for interfacing to CAN (FD), LIN, K-Line and SENT bus...
06.02.2019 10:00 Vector takes over Munich-based TESIS
Stuttgart/Munich, GERMANY, 2019-02-06 – Vector, the specialist for developing and testing software and vehicle electronics located in Stuttgart, Germany, has completed a full takeover of Munich-based TESIS GmbH. TESIS specializes in simulation solutions for virtual road testing – in particular, real...
17.01.2019 10:00 First Network Interface for Car2x/V2X Communication
Stuttgart, GERMANY, 2019-01-17 – Vector is presenting the VN4610 network interface – its first special solution for IEEE-802.11p and CAN-(FD) based applications. As an interface to the CANoe.Car2x test tool, the interface advances 802.11p-based ECUs to production readiness quickly. The VN4610 is a...
28.11.2018 11:00 VectorCAST Certified for Medical Software Engineering
Providence, RI, USA 2018-28-11 – VectorCAST, Vector's test automation platform, has been certified according to IEC 62304:2015 for medical software engineering. TÜV SÜD confirms that the development was performed in accordance with the life cycle processes for medical device software. Vector, the...
22.11.2018 11:30 Virtually Develop and Test AUTOSAR ECU Software Faster with vVIRTUALtarget from Vector
Stuttgart, GERMANY, 2018-11-22 – Vector introduces vVIRTUALtarget – a tool for virtual testing of AUTOSAR ECUs. It enables faster software development implementations in typical AUTOSAR-4 projects. The virtualized environment makes it possible to test the ECU software throughout the development ...
04.10.2018 10:00 Vector and Lauterbach Present a Development Solution for Software Debugging over the XCP Protocol
Stuttgart/Höhenkirchen-Siegertsbrunn, GERMANY, 2018-10-04 – Vector and Lauterbach are offering an integrated solution for ECU software development based on the new ASAM standard “Software Debugging over XCP”. It eliminates the need to repeatedly switch between hardware for measurement, calibration, ...
  «« « 1 2 3 4 5 » »»
 
 
 
» Vector
» Press Releases
» News by E-mail
Subscribe to our press
newsletter service for free
» News by RSS-Feed
Subscribe to the RSS-Feed
without any registration
» Contact Agency
MEXPERTS AG
Tel.: +49 (0)8143 59744-00
www.mexperts.de